Catch can will come in the package fully assembled.
The following parts are included in kit:

Catch Can
2' + 3/8 Hose
Spacer
17 MM Bolt

Tools needed for installation:

Ratchet or Wrench
Small Extension
13MM Socket
17MM Socket
Scissors or Sheers


Step 1
Pull of passengers side fuel rail cover.



Step 2.
If the FRC Grommets get stuck to the valve train covers remove them and reinstall them onto the FRC.

Step 3
Locate 3/8” hose behind the Throttle Body and remove from the crankcase and intake manifold.



Step 4
Hose removed from intake manifold and crank case.


Step 5
The above picture is what the removed hose should look like.


Step 6
Using a 13mm wrench or ratchet remove indicated bolt off the head.



WARNING:  The Catch Can is conductive so take precaution not to hit or touch the positive terminal on the battery during installation.  If needed disconnect the negative terminal.
Step 7
Keep Ground wire against the block when you install the catch can.


Step 8
Attach the two 3/8” rubber hoses to each end of the barbed fittings.


Step 9
Use the provided 17mm bolt to secure the catch can to the motor head.  Ensure the ground wire is touching the head.  Level the catch can and tighten the bolt.


Step 10
Cut rubber hose to desired length and push into the crack case and intake manifold ports.


Step 11
Billet Prototypes Catch Can installed.  Arrange your hoses accordingly.


Step 12
Install left Fuel Rail Cover (FRC) and push down as indicated in the picture above.

13.  Your Billet catch can install is now complete.  Empty catch can as required. Turn in direction of red arrow to loosen. Ever Motor has different characteristics so check it regularly.